Roll-formed in Farmville, NC — Greenville lots / NAP for walk-ins.
Your exact rafter run. No horizontal laps, no offcut waste.
One replacement sheet or a full subdivision.
We schedule our own line rather than queue behind a distributor.
Ridge, rake, eave, J-channel, closures, matched screws.
Volume pricing and consistent turnaround for repeat work.
Upstate South Carolina is served from our Farmville, NC plant (Greenville NC lots / NAP for walk-ins; SC lots for pickup), roughly half an hour from downtown Greenville, with additional lots at Easley, Pelzer, Anderson and Inman ringing the metro. Panels for Greenville SC jobs are rolled at Williamston rather than trucked from North Carolina, which is why lead times here match our home market instead of trailing it.
Our primary roll-forming line is in Greenville, North Carolina, with lots at 1940 N Memorial Dr and 1046 Greenville Blvd SW. For Pitt County customers this is as direct as it gets: raw coil goes in one end, your panels come off the line cut to your rafter run, and you collect them the same week. Order Tuesday, collect Thursday is a standard turnaround here, not a best case.
The bulk of our Greenville volume is 29-gauge in standard colours cut to exact rafter runs, plus the trim package — ridge cap, eave and rake, J-channel, foam closures and colour-matched screws. Re-roofs over existing shingles are common in both markets, and those need longer fasteners to reach solid framing. Tell us it is a recover job and we will spec the screws correctly rather than letting you find out on the roof.
METCO supplies Greenville, South Carolina from our Farmville, NC plant — SC Upstate lots for local pickupund the metro. Panels are roll-formed there and cut to your length, with no minimum order. Call (252) 375-3651.
Our main roll-forming plant is in Greenville, North Carolina, with lots at 1940 N Memorial Dr and 1046 Greenville Blvd SW. Panels come straight off the line cut to your rafter run — order Tuesday, collect Thursday on standard materials.
Yes, or you can collect from any lot. Delivery and setup are free within 100 miles for buildings; materials freight beyond the local radius is quoted transparently. For most Greenville-area jobs, collection is cheaper and faster.
Yes — that is the point of buying from a roll-former. A 27-foot 4-inch rafter run gets a 27-foot 4-inch panel: one continuous piece, no horizontal lap, no offcut. Suppliers who stock fixed lengths cannot do this.
Tell us the size, your county and what you are storing. We quote from current steel pricing — no obligation, and we will tell you if a different size suits you better.
