Single-run panels, no horizontal laps.
Gauge advice based on your actual spacing.
Ammonia and humidity kill cheap screws.
Same steel and colour for walls.
Volume rates for farm and contractor orders.
Collect locally across NC, SC and VA.
Barns and pole barns are typically framed with purlins further apart than a decked residential roof. Wider spans mean the panel is carrying more between supports, which is the one genuine argument for stepping up from 29-gauge to 26-gauge. Tell us your purlin spacing and we will tell you whether the upgrade is worth it for your framing or whether it is money better spent on screws.
Ammonia from manure, combined with humidity, attacks fasteners and coatings faster than ordinary weather. In livestock buildings the failure sequence is usually washers perishing, then screws backing out, then water at the fastener holes. Ventilation helps more than any panel upgrade, and fastener quality matters more than gauge. This is not a place to buy the cheapest screws available.
Barn roofs are often long slopes. Because we cut to order, a 40-foot run can go up as one continuous panel rather than two lapped pieces — no horizontal seam, nowhere for chaff and debris to collect, and one fewer leak path repeated across the whole building. On agricultural buildings that is usually the single biggest practical advantage of buying from a roll-former.
29-gauge is standard and correct for most pole barns. If your purlin spacing is wide, 26-gauge resists deflection between supports and is worth considering. Tell us the spacing and we will give you a straight answer rather than defaulting to the upsell.
Decades, with the caveat that fasteners and closures usually fail long before panels do. In livestock buildings, ammonia and humidity accelerate that — good ventilation and quality fasteners extend service life far more than heavier steel does.
Yes. We cut to order, so a 40-foot slope can be a single 40-foot panel with no horizontal lap. On agricultural buildings that removes a repeated leak path and stops debris collecting in seams.
Yes, in the same steel and the same colour run so walls and roof genuinely match. Remember the two panel lengths differ — roof is rafter run, siding is wall height.
Tell us the size, your county and what you are storing. We quote from current steel pricing — no obligation, and we will tell you if a different size suits you better.
